FAQ: LBS-0006-140

Q: Can I use the LBS-0006-140 with a flash suppressor on my M4/M16/AR15?

A: Yes, ensure the bore tool is in the barrel and seated against the flash suppressor with a tight fit.

Q: What calibers will the LBS-0006-140 work on?

A: This tool will work on .22 up to .50 caliber rifles.

Q: Will this bore tool work on a handgun?

A: Yes, the LBS-0006-140 will work on any handgun that has at least a 4 inch barrel length.

Q: Can I use the LBS-0006-140 on a .17 caliber?

A: No the LBS-0006-140 will not work on any calibers less than .22. Please see our bore tool LBS-1722-140 for .17-.22 caliber bore sighting.

Q: What are the four adapters made out of?

A: The four adapters are made from 100% DuPont Delrin® material.

Q: Will the adapters and the bore tool damage the finish inside the bore of my rifle/handgun?

A: The adapters and the bore tool will NOT harm your barrel.

Q: How do you sight in using the LBS-0006-140?

A: To use the bore tool, you would pick the correct adapter for the caliber you are sighting in. Tighten the bore tool in the bore of your gun with the roll switch facing up and so the tool does not move or wobble. Turn on the laser and adjust the center of the crosshairs/middle iron sight to be right on the laser dot. We then suggest going to your ranger for any fine turning you might need to do.

Q: How much distance do I need to use for bore sighting?

A: To obtain the best accuracy we recommend using 25-30 yards.

Q: What is 25-30 yards is not available?

A: The bore tool still can be used at a shorter distance of 15-25 feet. If this is the distance you are using, instead of placing the middle of your crosshairs/middle iron sight right on the red laser dot, you will adjust them to be 2-inches directly above the laser dot.

Q: How do I measure 2-inchs above the laser if I am doing the shorter distance?

A: Provided with the LBS-0006-140 is a target with numbers on the right hand side that range from .25-3.00. Simple use this target by pointing the laser dot in the bull eyes of the target and adjusting your crosshairs/iron sights to the “2.00” mark on the target. This will put you 2-inches above the laser dot.

Q: Where do you change the batteries on the LBS-0006-140?

A: The batteries are located inside the activation roll switch. The LBS-0006-140 uses 3 A76/LR-44/AG13 batteries. To change the batteries you simply turn the roll switch to the “on” position and pop out the roll switch. The batteries will slide out the end. When putting new batteries into the roll switch, make sure you put the positive side of the battery in first.

Q: How long is the battery life for LBS-0006-140?

A: The batteries will have a life of 1.5 hours continuously. If not used continuously, they will have a much longer life.

Q: Where can I purchase the batteries needed?

A: The batteries used in the LBS-0006-140 are standard camera/watch batteries. They can be located at a local Wal-Mart, drug store, Radio Shack, or any other location that sells batteries. You can also purchase 12-packs (BAT-0G13-140) from our website for $12 plus shipping.

Subscribe to back in stock notification